Exetools

Exetools (https://forum.exetools.com/index.php)
-   General Discussion (https://forum.exetools.com/forumdisplay.php?f=2)
-   -   Basic Disassembler for Delphi port of Micro Length-Disassembler Engine 32 (https://forum.exetools.com/showthread.php?t=8435)

redbull 11-04-2005 04:56

Basic Disassembler for Delphi port of Micro Length-Disassembler Engine 32
 
1 Attachment(s)
Hi All,

Converted uNdErX's Micro Length-Disassembler Engine 32. Written for FASM (Flat assembler), into a delphi compatable unit.

I left the calling convention as __cdecl, and have started on documenting the engine.

This little engine works so well that I slapped together a very basic disassembler.

Does not follow jumps and very few opcodes implemented, but it shows some interesting stuff for less than an hours work.

The disassembler was basically a test for the MLDE32 engine.

Full source included.

Enjoy
RedBull


All times are GMT +8. The time now is 17:12.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Always Your Best Friend: Aaron, JMI, ahmadmansoor, ZeNiX