How extract dup2 project from patcher.exe
 

Hi everyone.

In older versions of dUP2 patcher, (e.g. v2.22), it was possible to open the project directly from the patcher.exe; but in recent versions it has been gone.

Is there any way to extract the patch project from the patcher.exe?

Thanks

Read HERE some very good info about this subject.

Thanks buddy.

It worked. :)

For others may want to decompile a patcher, make sure that you put the correct RVA of load_patcher export function. It may vary for different versions of dup2patcher.dll.


AddressOfEntryPoint: 0x000020D0 -> 0x0000xxxx (<- Export: load_patcher)

Nice information. Thanks.

During the "decompilation", the target patcher (the one to decompile) will need to be run so, if it needs administrator rights (Vista/7/8/10), remember to launch the "parent" dup as admin too ... otherwise it will just say 'dump failed' :)

Regards,
Tony