Hello!
I'm new here, finally got an invitation so I hope not to dissapoint anyone. I've done a lot of hardware RE in the past, a bit less nowadays and there has always been some software RE but mostly embedded systems stuff.
Recently I took the decission of learning to reverse the tools I use for work, EDA software to be more specific, that in most cases is protected with FlexLM. I've learned a lot reading this site from the "outside", together with CRackZ and woodman forums and I've managed to defeat it several times.
I'm here to keep learning about FlexLM and share what I've learned on my own, I hope you guys help me out because I have lots of questions, I'm still a newbie
Cheers!