some quastion about armdillo...finger print..how it can be change it in ram?

[hrco]

Is it possible to setup (on older version it is)...to setup so I can get full working version of some protected sw if I have working key, finger and name?
on old version I start process open it in some ram editor finde it my finger (in some inversion look) change it in working.....and write name and key...and all is ok!
I try on some new version ....this trick not goes?
Any solution for this my problem?

Hi there ive done this before to test it out and it worked ok i cant remember what ver of armadillo it was tho, i figured out it made the ID from the computer name and the C: drive volume id so i change both of these which gave me the valid HW ID,
hope this helps
Wa||acE

[hrco]

becouse you can program armadillo to get data for finger print from any hardware part of your pc...