Code to efficiently break on entering code section???

		Exetools > General > General Discussion
Code to efficiently break on entering code section???

05-07-2005, 18:57

yaa

Posts: n/a

Code to efficiently break on entering code section???

Hello,

I'm writing a small tool and was wondering what might be the most efficient approach to break on entering the code section. Using EXCEPTION_SINGLE_STEP and checking at every step if EIP is in the code section is indeed slow. OllyDbg does this very efficiently, so there must be a better/faster way of doing it. How?

Thx.

yaa

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is Off HTML code is Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to enable Code section (Read / Write) in x64	New Tiger	General Discussion	14	02-23-2023 06:25
Addison.Wesley.Pub.Exploiting.Software.How.to.Break.Code	SOLAR	General Discussion	13	12-24-2004 01:18

All times are GMT +8. The time now is 08:24.