![]() |
|
#3
|
|||
|
|||
|
Italians, English, and Croats have access to CFE, where they either read the admin / supervisor password or upload non-branded firmware:
https://www.hwupgrade.it/forum/showthread.php?t=2891309 http://forum.pcekspert.com/showthread.php?p=2761531 https://www.boards.ie/vbulletin//showthread.php?t=2057302483 Unfortunately, my bootloader is password protected: https://paste.in/E9cN86 The only thing I managed to rip was the data I posted above. This is not a firmware dump. This is probably just a save of settings. I was able to read it after entering the address: IP_router/backupsettings.conf IP_router/configuration-backupsettings.conf IP_router/pages/tabFW/configuration-backupsettings.conf IP_router/dumpcfgdynamic.cmd IP_router/dumpmdm.cmd IP_router/dumpcfgdynamic.conf IP_router/password.cmd What unencrypted firmware are you writing about? You mean a file that someone ripped with a programmer directly from the bone, or a file from another router with an unblocked dump memory command? Even if I get such a file, it will not have the same version of the software as I have and will come from another operator. |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Signtelecom board st_vcu-v1.4 config | dnvthv | General Discussion | 0 | 07-11-2019 17:41 |
| vc2010 produced .obj is not a COFF type file ,there is anybody know why? | xiaohang99 | General Discussion | 4 | 05-15-2016 17:22 |