Code to efficiently break on entering code section???

		Exetools > General > General Discussion
Code to efficiently break on entering code section???

05-08-2005, 05:19

yaa

Posts: n/a

Hello Lunar_Dust,

I was not thinking of the initial breakpoint at the entry point of an application. I was thinking of a breakpoint placed for example on the .text section of a packed application.
OllyDbg is for sure not using EXCEPTION_SINGLE_STEP to break when you place a breakpoint on a PE section. It is too fast. I was then wondering how else you could accomplish such a task.

yaa

Last edited by yaa; 05-08-2005 at 08:11.

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is Off HTML code is Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to enable Code section (Read / Write) in x64	New Tiger	General Discussion	14	02-23-2023 06:25
Addison.Wesley.Pub.Exploiting.Software.How.to.Break.Code	SOLAR	General Discussion	13	12-24-2004 01:18

All times are GMT +8. The time now is 08:13.