|
|
#1
07-06-2015, 18:43
|
||||
|
||||
|
How extract dup2 project from patcher.exe
Hi everyone.
In older versions of dUP2 patcher, (e.g. v2.22), it was possible to open the project directly from the patcher.exe; but in recent versions it has been gone. Is there any way to extract the patch project from the patcher.exe? Thanks
__________________
In memory of UnREal RCE... 
|
|
#2
07-06-2015, 20:19
|
|||
|
|||
|
Read HERE some very good info about this subject.
|
| The Following 3 Users Say Thank You to uranus64 For This Useful Post: | ||
Newbie_Cracker (07-07-2015), tonyweb (07-08-2015) | ||
|
#3
07-07-2015, 15:45
|
||||
|
||||
|
Thanks buddy.
It worked.  For others may want to decompile a patcher, make sure that you put the correct RVA of load_patcher export function. It may vary for different versions of dup2patcher.dll. AddressOfEntryPoint: 0x000020D0 -> 0x0000xxxx (<- Export: load_patcher)
__________________
In memory of UnREal RCE...
|
|
#4
07-08-2015, 00:51
|
|||
|
|||
|
Nice information. Thanks.
During the "decompilation", the target patcher (the one to decompile) will need to be run so, if it needs administrator rights (Vista/7/8/10), remember to launch the "parent" dup as admin too ... otherwise it will just say 'dump failed' Regards, Tony
__________________
Want to learn unpacking ... but I'm too stupid 
|
| The Following User Says Thank You to tonyweb For This Useful Post: | ||
Newbie_Cracker (07-08-2015) | ||
 |
| Tags |
| dup2, patcher |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Full version of Project-52 and Project-AVR | Yaumen | General Discussion | 0 | 08-10-2004 16:27 |
Linear Mode
